| |
G.M.
Air Smog System Installation
 |
15. Position the passenger side clamp on to the check valve facing
downward as shown. |
 |
16. Position clamps on to the diverter valve assembly facing upward.
Note the white line vacuum hose with the white line running directly
on top attached to diverter vac nipple to vac tee. |
| If you’re doing a body-off restoration, you’ll
need to wait to put on the drive belts for the Smog Pump, AC, Power
Steering, etc. The water pump pulley and fan will be installed as
you are dropping the body. If you’re restoring a car with the
body on the frame then proceed with the installation of the pulley,
fan and belts and adjust to the manufacturer’s specifications.
At this point, you need to tighten all bolts and nuts covered in the
assembly. Then you’re ready for judging ! Its a win win situation!!!! |
|
|
|
