 |
3. Install check valves onto manifold tube using Copper Plus Sealer.
Use only a small amount on the threads so it won’t show when
completely assembled. |
 |
4. Tighten with a flare wrench crescent or open end wrench. Note
tape protection between wrench and nut! |
 |
5. Place a very thin application of Copper Plus on manifold tube
threads one side at a time. |
 |
6. Install manifold tube, being very careful not to scratch anything.
On the passenger side pull back the dipstick tube slightly for clearance
and set the tube in place. Turn a few threads on each outlet until
all are started, then proceed to tighten until all four are snug.
Tape or wrap a clean towel in and around the valve covers and cylinder
heads to avoid scratches. Ideally, a flared wrench should be used,
but a 9/16 open end will work if you tape it up carefully.”AS
SHOWN” |
 |
7. Install diverter outlet on pump using correct SB marked bolts
and new gasket. Tighten to 10 ft lbs. |
 |
8. Install Chevrolet Orange pump bracket to pump, using the long
TR bolt and spacer if so equipped. Do not tighten at this time. |
|
